Freedome blocks a program to start / Windows 10

JK-RODO
JK-RODO Posts: 7 New Member

If Freedome is active and connected it does not allow Creo Parametric 4.0 to start.

When I disable the the protecting Creo starts as normal.

 

Is there a way to set Freedome to ingnore a specific program in Windows 10?

Comments

  • Hi JK-RODO,

     

    Have you tried to turn off Tracking Protection in Freedome and check if Creo Parametric 4.0 is able to start?

     

    What happens when you start Creo Parametric 4.0 first when Freedome is off and then turn on Freedome again? Does it have any effect on it?

  • JK-RODO
    JK-RODO Posts: 7 New Member

    Creo does not start even with tracking protection is off.

    I need to disable Freedome completely.

     

    After Creo has started I can enable Freedome without any problems.

This discussion has been closed.
Product & Pricing Info