What is the firewall configuration requirement for F-Secure Rapid Detection Service (RDS) network sensor?
As the device needs to call the RDS backend for collection and management purposes, you must allow connections to the following hosts:
doorman.sc.fsapi.com over TCP port 443 lorsp.sc.fsapi.com over TCP port 443 lorsp.sc2.fsapi.com over TCP port 443 por1-timon-alpha02.sp.f-secure.com over TCP ports 4505 and 4506 time.f-secure.com over UDP port 123
Should there be no way of whitelisting on a per-domain basis, IP addresses are provided below:
220.127.116.11 over TCP port 443 18.104.22.168, 22.214.171.124, 126.96.36.199 over TCP port 443 188.8.131.52 over TCP ports 4505 and 4506 184.108.40.206, 220.127.116.11, 18.104.22.168, 22.214.171.124 over UDP port 123
Note: The IP addresses can change due to modifications to the backend environment; use the command dig +noall +answer <domain.to.check> (Linux) or nslookup <domain.to.check> (Windows) to get the IP address to which the domain <domain.to.check> resolves.
Article no: 000003525
If installing the sensor does not succeed, follow these steps to troubleshoot:Check that the sensor.conf file is copied to the correct location and has the correct privileges, and then rerun the installation.