VyprVPN configured with Cleint Security 9+

RdjPZV6iMt2X95mRdjPZV6iMt2X95m Posts: 7
in Business Security

 

 

Hello

 

I've just purchased the VPN called VyprVPN App from Golden Frog.

 

I can get the VPN to work if the firewall portion of Client Security is turned off. But I still cannot track what it is that will stop VyprVPN App 1.4.1 from working if Client Security’s firewall is turned on.

 

VyprVPN will work however if the Client Security firewall is on but the ‘Current firewall profile’ used is ‘Allow All' or 'Office'

.

I think it may be related to outbound UPC connections if one compares the profile of Office and Home. But I’m not sure how to create/add a rule that lloks like the rule under the Home priole 'Outboud TCP and UCP traffic'..

 

I normally use the Home profile so if any one would be kind enough to help me out that would be appreciated.

 

Regards

Like

Comments

  • JaysonJayson Posts: 595

    Hi,

    I have moved your post to End-point Security board as you are using Client Security. Kindly refer the steps in this post to create service and firewall rules, replace with the ports required for your VPN client. You might find some useful informations here as well.

    Thanks.

    Best Regards,
    Jayson

    Like
  • RdjPZV6iMt2X95mRdjPZV6iMt2X95m Posts: 7

    Oh I see Jason.

     

    Thanks

     

    Regarding the link you sent me, how do I know it is applicable to software VPN I'm using?

     

    https://community.f-secure.com/t5/End-point/Setting-firewall-rules-in-F/m-p/17030#M752

    Like
  • RdjPZV6iMt2X95mRdjPZV6iMt2X95m Posts: 7

     

    I have just received this information from them. In the link you gave me Jason for creating the Rule you mention after the created service from the first step is taken, you stated 'select the direction'. How do I do this? Until I do the 'Next' button is greyed out.

     

    Any chance you could give me step-by-step instructions regarding the info I've got from them below please.

     

    Thanks

     


    PPTP:
    To allow PPTP tunnel maintenance traffic, open TCP 1723.
    To allow PPTP tunneled data to pass through router, open Protocol ID 47.

    L2TP over IPSec:
    To allow Internet Key Exchange (IKE), open UDP 500 and 4500
    To allow IPSec Network Address Translation (NAT-T) open UDP 5500, 4500? 
    To allow L2TP traffic, open UDP 1701.

    OpenVPN
    1194 Best encryption, 443 faster
    Like
  • RdjPZV6iMt2X95mRdjPZV6iMt2X95m Posts: 7

    I see the 'select the direction' is the rule.

     

    As I mentioned the 'Next' button reamains greyed out.

    Like
  • VadVad Posts: 1,062 F-Secure Employee

    Hello,

     

    To select the direction just press left mouse button pointing to the question mark in "Direction" column.

     

    Hope this helps,

    Vad

    Like
  • RdjPZV6iMt2X95mRdjPZV6iMt2X95m Posts: 7

     

    Oh I see. Thanks for that Vad -)

     

    I will get around to reading the help file soon.

    Like
This discussion has been closed.